First I cut out all my pieces for the Reveal Wheel. I cut the base panel, the 2 wheel pieces and the arrow out of white cardstock. I colored the arrow with a Copic Marker that I used for my stamped images so it matches perfectly, but you could just use colored cardstock for this. I cut a second base panel, this time with the curved window, out of some Spiffy Speckles paper. To make the hillside I cut out a piece of Watercolor Wishes paper with the same die, just big enough for the hill. I ran that piece through my die cutting machine again with a Simple Stitched Hillside Border.
I stamped all my images on Copic friendly cardstock using Memento Tuxedo Black ink and colored them with Copic Markers in various spring colors. I mainly used stamps from Eggstra Amazing Easter and added some butterflies from Butterfly Kisses. I used low stick tape to hold the matching dies in place and ran them through my die cutting machine.
I used the Reveal Wheel Templates to layer over the wheel that I cut out so the placement of my stamps is perfect. I stamped sayings from the Reveal Wheel Spring Sentiments on the wheel. I also stamped the ‘Hope your easter is’ above the window to complete the sentiment.
Now it’s time to put the Reveal Wheel together! I used a brad to secure the 2 wheel pieces together and added foam tape on the back piece. I lined up one of the sentiments on the wheel with the window, lined up my 2 base panels and stuck down the wheel. I added foam tape all around the wheel on the panel and adhered my front panel to it.
I added all my stamped images and the hillside to the card using an adhesive roller. I cut out the largest Inside Out Stitched Scalloped Rectangle Stackable and layered my card onto it. I scored a 4,25 by 11 inch piece of cardstock in half and added the entire card panel onto it. To finish off, I added the little arrow.